I am upgrading the processor in an embedded system for work. This is all in C, with no OS. Part of that upgrade includes migrating the processor-PC communications interface from IEEE-488 to USB. I finally got the USB firmware written, and have been testing it. It was going great until I tried to push through lots of data only to discover my USB connection is slower than the old IEEE-488 connection. I have the USB device enumerating as a CDC device with a baud rate of 115200 bps, but it is clear that I am not even reaching that throughput, and I thought that number was a dummy value that is a holdover from RS232 days, but I might be wrong. I control every aspect of this from the front end on the PC to the firmware on the embedded system.
I am assuming my issue is how I write to the USB on the embedded system side. Right now my USB_Write function is run in free time, and is just a while loop that writes one char to the USB port until the write buffer is empty. Is there a more efficient way to do this?
One of my concerns that I have, is that in the old system we had a board in the system dedicated to communications. The CPU would just write data across a bus to this board, and it would handle communications, which means that the CPU didn't have to waste free time handling the actual communications, but could offload the communications to a "co processor" (not a CPU but functionally the same here). Even with this concern though I figured I should be getting faster speeds given that full speed USB is on the order of MB/s while IEEE-488 is on the order of kB/s.
In short is this more likely a fundamental system constraint or a software optimization issue?