Memory Mapped files and atomic writes of single blocks

user_22227 0
Viewed 4003

If I read and write a single file using normal IO APIs, writes are guaranteed to be atomic on a per-block basis. That is, if my write only modifies a single block, the operating system guarantees that either the whole block is written, or nothing at all.

How do I achieve the same effect on a memory mapped file?

Memory mapped files are simply byte arrays, so if I modify the byte array, the operating system has no way of knowing when I consider a write "done", so it might (even if that is unlikely) swap out the memory just in the middle of my block-writing operation, and in effect I write half a block.

I'd need some sort of a "enter/leave critical section", or some method of "pinning" the page of a file into memory while I'm writing to it. Does something like that exist? If so, is that portable across common POSIX systems & Windows?

acid fwrite mmap atomic
2 Answers

If I read and write a single file using normal IO APIs, writes are guaranteed to be atomic on a per-block basis. That is, if my write only modifies a single block, the operating system guarantees that either the whole block is written, or nothing at all.

In the general case, the OS does not guarantee "writes of a block" done with "normal IO APIs" are atomic:

  • Blocks are more of a filesystem concept - a filesystem's block size may actually map to multiple disk sectors...
  • Assuming you meant sector, how do you know your write only mapped to a sector? There's nothing saying the I/O was well aligned to that of a sector when it's gone through the indirection of a filesystem
  • There's nothing saying your disk HAS to implement sector atomicity. A "real disk" usually does but it's not mandatory or a guaranteed property. Sadly your program can't "check" for this property unless its an NVMe disk and you have access to the raw device or you're sending raw commands that have atomicity guarantees to a raw device.

Further, you're usually concerned with durability over multiple sectors (e.g. if power loss happens was the data I sent before this sector definitely on stable storage?). If there's any buffering going on, your write may have still only been in RAM/disk cache unless you used another command to check first / opened the file/device with flags requesting cache bypass and said flags were actually honoured.

user_27329690
Related