I'm doing a robot navigation and path planning project based on simulating the turtlebot3 and driving with the A* planner.
I'm using a program that allows the robot to plan a route only through 'cells' with no cost value (aka. freespace with an inflation cost of 0). However, adjusting the inflation radius I'm experiencing that the robot either cannot pass through narrow openings when the inflation is higher, but drive along a wall when it is low.
I'm wondering if there is a way to control the inflation or something? My desires outcome is for the robot to drive in the center of wide hallways, not along walls, but be able to pass through doors that it should be able to fit through.
Thank you.